Do’s and Don’ts When Performing Ceramic Tile Installation

How to Lay Ceramic Tile the Right Way  

Ceramic tile installation is a job that most homeowners can do themselves. However, when you are considering taking on this project, there are a few things that you need to bear in mind. The following are some do’s and don’ts when it comes to laying ceramic tile.

Dos

One thing you want to make sure you do when you are laying ceramic tile is to buy extra material. Most people make the mistake of buying the exact square footage, wrong. When you install ceramic tile, you must buy at least an extra 5% more, or even 10%. This will ensure you have enough to cover any cuts or waste. It can be very hard to find an exact match later should you run out of tile.

When you are laying ceramic tile, you need to make sure to use tile spacers throughout the project. Some people get in too much of a hurry and think they can do the job without using tile spacers. They lay the job by hand and when the job is done, it looks bad. So try to resist the temptation to lay the job freehand.

Don’ts

Don’t walk on the tile before the adhesive has had time to dry. Many people make the mistake of thinking they can walk on the tile before the adhesive has cured and it does not matter. At that point, you will need to tear up the floor and relay it. You must allow at least 24 hours after the tile has been laid with most tile adhesives.

You also want to avoid starting the job from the side of a room. If you are installing tile in a large room, take the proper steps to center the floor before getting started. This involves using a tape measure and a chalk line. You will need to snap a chalk line in both directions so you will know exactly where the center of the floor is.

If you would like professional ceramic tile installation done and you live in the Norman, OK area, make sure to call T.G. Installations first at this number (405) 451-2574 for an appointment.

Review Us /footer>